User Tools

Site Tools


uplink_frequency

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
uplink_frequency [2019/02/10 21:30]
kd6kpc
uplink_frequency [2021/02/27 14:11] (current)
Line 1: Line 1:
 ====== Uplink Frequency ====== ====== Uplink Frequency ======
-To reduce confusion as to which frequency is being referenced in terms of a paired frequency set (duplex with separate input and output frequencies, as repeaters typically use, the uplink frequency refers to the frequency that the repeater is receiving on. This is the frequency that is programmed into the user radio (HT, mobile, base) that you transmit to the repeater on. This is the radio's transmit frequency. Some radios are wquipeed with automatic offset and the user does not actually program in a transmit frequency, but simply indicates if the repeater is a positive (+) or negative (-) shift. 
  
-Confusion sometimes occurs when it is not known from which radio, the user's or the repeater's, that is being requested. Usually, it seems to get turned around when a repeater owner enters that data. Many repeater coordination councils request the repeater's frequencies in terms of the repeater's transmit and receive frequencieswhich are opposite from the user radio's on a duplex system.+RepeaterBook enters all data from the perspective of the remote (user) radionot the repeater.
  
-Repeaterbook enters and displays data from the perspective of the remote (user) radio.+To reduce confusion as to which frequency is being referenced in terms of a paired frequency set (duplex with separate input and output frequencies, as repeaters, typically use, the uplink frequency refers to the frequency that the repeater is receiving on. This is the frequency that is programmed into the user radio (HT, mobile, basethat you transmit to the repeater. This is the radio's transmit frequency. Some radios are equipped with automatic repeater offset/shift so the user does not actually program in a transmit frequency but simply indicates if the repeater has a positive (+) or negative (-) shift.
uplink_frequency.1549855842.txt.gz ยท Last modified: 2021/02/27 14:09 (external edit)