The Yaesu ADMS-12 software is specifically for programming the Yaesu FTM-300DR radio. Also, the transceiver parameters and the setup menu items may be edited and configured.
The radio is shipped with a micro-USB cable. This cable is NOT for programming the radio. It is only for performing firmware updates. The cloning cable is the SCU-20 which must be purchased separately.
An alternative and preferred method for programming the radio is with a microSD card. A microSD card is not included with the radio but can be purchased separately.
RepeaterBook recommends a microSD card no larger than 32 GB. The radio is not capable of reading larger cards. The card featured above has been tested in two separate FTM-300DRs and has worked perfectly.
As an alternative to the ADMS-12 software, you can also use the RT Systems programmer.
The software can import and export in the following formats:
This version of the ADMS software is supported by RepeaterBook. A full list of the supported searches can be found below.
The FTM-300DR supports 999 memory channels.
| Search Page | North America | Rest of World |
|---|---|---|
| Favorite | Operational | Operational |
| Feature | Operational | Operational |
| Keyword | Operational | Operational |
| Location | Operational | Operational |
| Multi-County | Development Planned | |
| Multi-State | Development Planned | |
| Proximity | Operational | Operational |
| Proximity 2.0 | Operational | Operational |
| Quick | Operational | Operational |
| Travel | Operational | Operational |
There are no header field names in the file. RepeaterBook defaults are BOLD.
| Field Name | Field Value |
|---|---|
| Channel No | Sequential beginning with 1 |
| Receive Frequency | |
| Offset Frequency | Shift in MHz |
| Offset Direction | -RPT, +RPT, -/+, OFF |
| Operating Mode | AM, FM |
| DIG/ANALOG | FM, AMS, DN |
| Name | |
| Tone Mode | OFF, TONE, TONE SQL, DCS, REV TONE, PR FREQ, PAGER |
| CTCSS Frequency | Repeater uplink tone or 88.5 |
| DCS Code | Repeater uplink DCS Code or 023 |
| User CTCSS | 1600 Hz |
| RX DG-ID | Downlink DG-ID or RX 00 |
| TX DG-ID | Uplink DG-ID or TX 00 |
| TX Power | HIGH, MID, LOW |
| M-GRP | OFF |
| SCAN | YES, NO |
| Step | 5.0KHz |
| Narrow | OFF |
| Clock Shift | OFF |
| Comment | |
The RepeaterBook export automatically filters unsupported frequencies and digital modes.
The frequencies exported are between 100 MHz and 1000 Mhz.